... : Hope you are taking pics of all the work you are doing on this. Hi Rob, I will try to report the good bits and hide the bad bits. Here are the first prints with the 0.6mm nozzle for the timbers (this is 0 gauge). I want to get the timbers looking reasonable before I try printing chairs on them. I set the timbers 2.75" thick (1.6mm), which is about half most 0 gauge flexi-track, but anything thicker will take a fortnight to print. 2_141435_020000000.jpg On the left was printed using 0.15mm layers. The ribs are too flimsy and distorted in removing it from the workbed. On the right I changed to 0.2mm layers for faster printing, and I beefed up the ribs (which slowed it back down). The results are very accurate for size (59.5 x 5.8 x 1.6 mm), and with surprisingly sharp edges (at least to me). The biggest problem is the knobbly top surface: 2_141446_140000000.jpg It's not a bad as that close-up, and would ...