... my best with the top curve but its not good enough. Thanks Richard posted: 20 Apr 2010 21:54 from: Martin Wynne Richard Spratt wrote: want to end both curves below so that they are perpendicular to the baseboard edge which happens to line up with the pad grid. I've used the turnout length in angular swing, but I don't know the angle of the start end. Hi Richard, Put the peg on the fixed end of the template, and then note the peg angle from the info panel: 2_201642_590000000.png Then you can calculate the desired swing angle for the template. In this case, the required swing angle would be 180- 102.21 degrees= 77.79 degrees. Enter this angle at geometry> swing angles (in degrees) ... menu item. As a double-check, you can then swap the peg to the other end, and check the peg angle again. The peg angle is zero (or 180 degrees) when the peg arms are horizontal on the screen, and increases in the anti-clockwise ...