... as they will be hidded, a standard 1-6 was built 982_010400_140000000.jpg Sorry cannot up load it horizontally. A trial at making the infill out of card was started, proved a lot less messy than plaster or clay, but unless I solidify/stabilize it its hard to work to the correct size. Thought about using plastic, plain plasticard would be a too hard of finish, embossed might be too difficult to keep in register. I think either ply or balsa would be easier to work and give a softer finish 982_010410_500000000.jpg As you can see some of the cutting is better than others, but as I said its a test, the flairind on the check rails needs to be less (Machined?) and against the outside of running rails filler can be used. Also I have learnt what can and cannot be done with switch rails Still proves it can work, I will try the next turnout with Ply, perhaps I could even use air dried clay in a partially dried condition posted: 1 May 2020 14:44 from: Phil ...