... first crossing rail, after doing this check its in gauge with the other stock rail posted: 23 Nov 2014 08:29 from: Hayfield 982_230326_250000000.jpg Rails now fitted and tested with a long wheelbase van, will test next with a loco before fitting the Exactoscale slip and obtuse crossing chairs and anchoring down the central crossing to the sleepers Last edited on 23 Nov 2014 08:30 by Hayfield posted: 26 Nov 2014 07:48 from: Hayfield I thought a couple of images of how I build the obtuse crossings may assist 982_260217_530000000.jpg As you can see I build my turnouts and crossings on tracing paper, and each sleeper is held in place on 2 strips of very thin double sided tape which run the length of the unit. I have attached the chairs to the sleepers on all but the centre 5 sleepers. I build the crossings on C&L 0.5mm copperclad strip. You can see I have pealed back the paper on one side of the crossing and cut both pieces of strip flush with the rails. I then superglue these two copperclad strips ...