... can see I build my turnouts and crossings on tracing paper, and each sleeper is held in place on 2 strips of very thin double sided tape which run the length of the unit. I have attached the chairs to the sleepers on all but the centre 5 sleepers. I build the crossings on C&L 0.5mm copperclad strip. You can see I have pealed back the paper on one side of the crossing and cut both pieces of strip flush with the rails. I then superglue these two copperclad strips to their sleeper 982_260230_130000000.jpg I then do exactly the same to the other side, but leave the centre full length piece of copperclad intact whilst the superglue and chairs set fully 982_260235_590000000.jpg The half chairs that are fitted are super glued to the rails for added strength and glued using solvent to the sleepers, as I said I now let everything set thoroughly before repeating the process on the final copperclad strip I use the C&L 0.5mm strip out of convenience, any piece of strip metal 0.5mm thick or less would do. You could also use the ...