Search
Martin Wynne
Admin
- Location
- West of the Severn UK
- Info
- .
Enjoy using Templot?
Thanks.
Please do not send requests for help direct to me via email.
Post your questions on the forum where everyone can see them and add
helpful replies.
@Steve_Cornford @James Walters @Hayfield @Phil O @Phil G
parallel-wing crossover
even at present you can get most of the way there, as you can see.
the chairing conflicts at 1 can be resolved in several ways:
model:
prototype:
I haven't done either of those chairs yet, nor completed the chair heaving function to allow the swaps. I would likely be near to have that ready for an initial test by now, but for my accident. As it is it is going to take a while.
chairing errors at 2 and 3 on the lengthened BB chair for parallel wings need addressing too. at 2 there is no middle jaw, which needs adding as a slide-in insert similar to DD.
asymmetric AB/BB parallel-wing chairs are not yet done. the flaring error at 3 can be resolved by extending the flare bend clear of the chair jaw. the result at 4 looks fine -- I wouldn't be surprised if that's not a frequent prototype arrangement too.
for how to do this stuff, see my next post. i am finding working the computer agony at present and i want to suggest some changes
martin.
parallel-wing crossover
even at present you can get most of the way there, as you can see.
the chairing conflicts at 1 can be resolved in several ways:
model:
file the corners off the chairs to clear. the sockets are clear, so it will work ok and barely notice;
or skew the timber a bit to increase the chair separation.
prototype:
most likely -- swap the L1 to an M1 which is 3/8" shorter at that end and would probably clear;
or swap the CC to an L1CC if it doesn't.
I haven't done either of those chairs yet, nor completed the chair heaving function to allow the swaps. I would likely be near to have that ready for an initial test by now, but for my accident. As it is it is going to take a while.
chairing errors at 2 and 3 on the lengthened BB chair for parallel wings need addressing too. at 2 there is no middle jaw, which needs adding as a slide-in insert similar to DD.
asymmetric AB/BB parallel-wing chairs are not yet done. the flaring error at 3 can be resolved by extending the flare bend clear of the chair jaw. the result at 4 looks fine -- I wouldn't be surprised if that's not a frequent prototype arrangement too.
for how to do this stuff, see my next post. i am finding working the computer agony at present and i want to suggest some changes
martin.
message ref: 9060