Tony W
Member
- Location
- North Notts
Hello Martin.
I have been trying to alter the basic timbering alignment of a crossover by adjusting the track spacing as I have done many times in the past, but on this occasion this did not work as expected.
On further investigation I discovered the following.
If I alter the track spacing to 45mm (P4 gauge) and create adjacent tracks, all is well.
However if I change the track spacing to 45.1mm and create adjacent tracks the end result has changed back to 45.0mm.
Even stranger, if I alter the track spacing to 45.2mm and create adjacent tracks the end result comes out at 45.33mm.
I have tried several versions from 232b to 236c and they all do the same.
My system runs Windows XP but I can't see that having a bearing on it.
Regards
Tony.
I have been trying to alter the basic timbering alignment of a crossover by adjusting the track spacing as I have done many times in the past, but on this occasion this did not work as expected.
On further investigation I discovered the following.
If I alter the track spacing to 45mm (P4 gauge) and create adjacent tracks, all is well.
However if I change the track spacing to 45.1mm and create adjacent tracks the end result has changed back to 45.0mm.
Even stranger, if I alter the track spacing to 45.2mm and create adjacent tracks the end result comes out at 45.33mm.
I have tried several versions from 232b to 236c and they all do the same.
My system runs Windows XP but I can't see that having a bearing on it.
Regards
Tony.
message ref: 5316