BetweenTheTunnels
Member
- Location
- UK
Martin,
When I responded to a post on Western Thunder from @Hayfield (I think) about 3D printing with 3mm rail (Code 60 I think) - see this post - you asked me if I had some suitable 3mm/ft bullhead rail and did I know the dimensions to enter in Templot.
The rail from the 3mm Society has now arrived - is there a post somewhere that says what measurements need to be taken and where they are entered in Templot? I have tried a search around rail dimensions on this forum but haven't come up with anything. Initially I am just in the designing stage, but am looking to 3D print a 3mm/ft point off over Christmas.
Cheers
Richie
When I responded to a post on Western Thunder from @Hayfield (I think) about 3D printing with 3mm rail (Code 60 I think) - see this post - you asked me if I had some suitable 3mm/ft bullhead rail and did I know the dimensions to enter in Templot.
The rail from the 3mm Society has now arrived - is there a post somewhere that says what measurements need to be taken and where they are entered in Templot? I have tried a search around rail dimensions on this forum but haven't come up with anything. Initially I am just in the designing stage, but am looking to 3D print a 3mm/ft point off over Christmas.
Cheers
Richie
message ref: 9540